Kernel driver corsair-cpro¶
Supported devices:
Corsair Commander Pro
Corsair Commander Pro (1000D)
Author: Marius Zachmann
Description¶
This driver implements the sysfs interface for the Corsair Commander Pro. The Corsair Commander Pro is a USB device with 6 fan connectors, 4 temperature sensor connectors and 2 Corsair LED connectors. It can read the voltage levels on the SATA power connector.
Usage Notes¶
Since it is a USB device, hotswapping is possible. The device is autodetected.
Sysfs entries¶
in0_input |
Voltage on SATA 12v |
in1_input |
Voltage on SATA 5v |
in2_input |
Voltage on SATA 3.3v |
temp[1-4]_input |
Temperature on connected temperature sensors |
fan[1-6]_input |
Connected fan rpm. |
fan[1-6]_label |
Shows fan type as detected by the device. |
fan[1-6]_target |
Sets fan speed target rpm. When reading, it reports the last value if it was set by the driver. Otherwise returns an error. |
pwm[1-6] |
Sets the fan speed. Values from 0-255. Can only be read if pwm was set directly. |
Debugfs entries¶
firmware_version |
Firmware version |
bootloader_version |
Bootloader version |